Minimum Height 350mm - Maximum Height 2600mm
Recess Fit
1. Measurements are required to be in millimeters (mm).
2. The depth of the reveal where the shutter or frame will be mounted needs to be measured, to ensure no mullions, handles or key locks etc. will interfere with the operation of the blades when open. When ordering with Hidden tilt rods, measured from the front edge of the frame, 89mm blades need 67mm, 63mm blades need 55mm
3. This depth will then determine the framing options available to suit the requested blades.
4. Measuring for inside reveal (recess) fit the shutters should be measured in three places across the width and the drop and the smallest measurements provided.
Face Fit
1. Measurements are required to be in millimeters (mm).
2. When ordering Face (outside) Fit shutters it is suggested to use the matching frame sizes to ensure the blades clear any architraves or walls that the frames are being mounted to.
3. Measuring for outside (face) fit the shutters should be measured in three places across the width and the drop and the largest measurement provided where the outside of the shutter frame is to be installed.
4. If the opening has an architrave the OUT measurements are usually from the outside of the architrave, to the outside of the opposite architrave. If there is no architrave, add the width of the frame to the recess measurement to find the outside of frame measurements.
Mid Rail is required on Panels over 1500mm.
Mid Rail(s) (when required) will be placed at even spacings on the Panel
unless otherwise requested.
For Shutters in a frame, please measure from the bottom of the opening
to the centre of the Mid Rail(s)
For Panels only, please measure from the bottom of the Panel
to the centre of the Mid Rail(s)
Only one Critical Midrail is allowed.
Mid rail height
On panels over 1500 in height, a mid-rail height is necessary for stability. We will put it in the centre of the panel, but if you want to align it with something like a window sash, provide a measurement from the bottom of your window to the middle of the obstacle.
Measure the hard drop from the left, centre, and right of the window recess. Write down the smallest width and drop measurement. Note; Special attention should be given to window openings that have window winders, latches, security devices, removable screens, etc, because they may obstruct the frame.
*Do not take any deductions (U Blinds Online will do this for you)